Makin' a Mask Part 2

Here's the next set!

5. Took a few hours of eyeballing and cutting to get the two sides to connect in a strait line. Since the two halves connect at an angle, this was more difficult than I had anticipated. ^ ^;

6. Used PVC glue to attach scrap pieces onto the inside to keep the warped portions in place and add integrity. These pieces were heated to the point of being wet noodles, then set into place.

7. More of the warping and gluing of support pieces.

8. Working on figuring out exactly how the eye hole should look ^ ^; that was a whole bunch of drawing and erasing.

:3 well, thank you for taking a look. Again, I want to see if anyone can guess what webcomic I got this idea from, it'll be more obvious as I upload these. Wish me luck!